Differences between revisions 3 and 7 (spanning 4 versions)

Raspberry Pi Pico

Contents

Raspberry Pi Pico

Raspberry Pi Pico is a low-cost, high-performance microcontroller board with flexible digital interfaces.

raspberry pi pico pinout

https://www.raspberrypi.com/documentation/microcontrollers/raspberry-pi-pico.html#pinout-and-design-files

alt text

Run-Reset button (right side)

To help set mass storage with BOOTSEL + RUN-Reset button

Connect with micro-usb

Click on BOOTSEL button to enable mass storage

   1 sudo dmesg
   2 # [ 3570.065996] usb 1-4.3: Product: RP2 Boot
   3 # [ 3570.066006] usb 1-4.3: Manufacturer: Raspberry Pi
   4 # [ 3570.066016] usb 1-4.3: SerialNumber: E0C9xxxxxxxx
   5 # [ 3570.163372] usb-storage 1-4.3:1.0: USB Mass Storage device detected
   6 # [ 3570.164049] scsi host2: usb-storage 1-4.3:1.0
   7 # [ 3570.164381] usbcore: registered new interface driver usb-storage
   8 # [ 3570.180142] usbcore: registered new interface driver uas
   9 # [ 3571.192940] scsi 2:0:0:0: Direct-Access     RPI      RP2              3    PQ: 0 ANSI: 2
  10 # [ 3571.194468] sd 2:0:0:0: Attached scsi generic sg1 type 0
  11 # [ 3571.195164] sd 2:0:0:0: [sdb] 262144 512-byte logical blocks: (134 MB/128 MiB)
  12 # [ 3571.195818] sd 2:0:0:0: [sdb] Write Protect is off
  13 # [ 3571.195830] sd 2:0:0:0: [sdb] Mode Sense: 03 00 00 00
  14 # [ 3571.196325] sd 2:0:0:0: [sdb] No Caching mode page found
  15 # [ 3571.196335] sd 2:0:0:0: [sdb] Assuming drive cache: write through
  16 # [ 3571.217448]  sdb: sdb1
  17 # [ 3571.237585] sd 2:0:0:0: [sdb] Attached SCSI removable disk
  18

Serial USB ttyACM0

   1 sudo dmesg
   2 # [9067045.808125] usb 1-1.3: new full-speed USB device number 7 using dwc_otg
   3 # [9067045.941554] usb 1-1.3: New USB device found, idVendor=2e8a, idProduct=000a, bcdDevice= 1.00
   4 # [9067045.941564] usb 1-1.3: New USB device strings: Mfr=1, Product=2, SerialNumber=3
   5 # [9067045.941568] usb 1-1.3: Product: Pico
   6 # [9067045.941572] usb 1-1.3: Manufacturer: Raspberry Pi
   7 # [9067045.941577] usb 1-1.3: SerialNumber: E661xxxxxxxxxxxx
   8 # [9067045.944106] cdc_acm 1-1.3:1.0: ttyACM0: USB ACM device
   9 apt install picocom 
  10 picocom -b 115200 --echo /dev/ttyACM0

-  ⇤ ← Revision 3 as of 2024-05-04 17:56:24 → 
  Size: 1826
  Editor: vitor
  Comment:
+   ← Revision 7 as of 2024-05-05 19:06:46 → ⇥
  Size: 2685
  Editor: vitor
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 12:
+== raspberry pi pico pinout ==
-Line 14:
+Line 15:
+{{attachment:pinoutrpipico-h.png|alt text|width=800 }}

== Run-Reset button (right side) ==
To help set mass storage with BOOTSEL + RUN-Reset button 
{{attachment:reset-run-button.jpg|alt text|width=800 }}
-Line 37:
+Line 43:
+Serial USB ttyACM0
{{{#!highlight sh
sudo dmesg
# [9067045.808125] usb 1-1.3: new full-speed USB device number 7 using dwc_otg
# [9067045.941554] usb 1-1.3: New USB device found, idVendor=2e8a, idProduct=000a, bcdDevice= 1.00
# [9067045.941564] usb 1-1.3: New USB device strings: Mfr=1, Product=2, SerialNumber=3
# [9067045.941568] usb 1-1.3: Product: Pico
# [9067045.941572] usb 1-1.3: Manufacturer: Raspberry Pi
# [9067045.941577] usb 1-1.3: SerialNumber: E661xxxxxxxxxxxx
# [9067045.944106] cdc_acm 1-1.3:1.0: ttyACM0: USB ACM device
apt install picocom 
picocom -b 115200 --echo /dev/ttyACM0 
}}}